Operation of BB Gun

BB guns can use any of the operating mechanisms used for air guns; see the powerplant technology section of the air gun article. However, due to the limited accuracy and range inherent in the BB gun, only the simpler and less expensive mechanisms are generally used.

Since nearly all BBs used today are steel, it is common to find BB guns that use magnets in their loading mechanisms. Since the BB is too hard to be swaged to the bore size, magnets are often used to hold the BB at the rear of the barrel--otherwise, the BB would simply roll out of the barrel if it were held at a downward angle.

The traditional, and still most common powerplant for BB guns is the spring piston type, usually patterned after a lever action rifle or a pump action shotgun. The lever action rifle was the first type of BB gun, and still dominates the inexpensive youth BB gun market. The Daisy Model 25 BB gun, modeled after a pump action shotgun with a trombone pump action mechanism, dominated the low price, higher performance market for over 50 years. Lever action models generally have very low velocities, around 275 ft/s, a result of the weak springs used to keep cocking efforts low for use by youths. The Daisy Model 25 BB gun typically achieved the highest velocities of its day, ranging from 375 ft/s to 450 ft/s. Lever action guns often have huge ammunition capacities; one of Daisy's early lever action models held 1000 BBs, in contrast to the Daisy Model 25 which held only 50 BBs. The ammunition in the lever action BB guns is gravity fed, such that the gun must be held at the proper angle when cocked to load the ammunition. The ammunition in the Daisy Model 25, on the other hand, is spring loaded, and no shift in gun angle is required to reload another BB.

Multi-pump pneumatic guns are also common--many youth oriented pneumatic pellet guns provide the ability to use BBs as a cheaper alternative to lead shot. These guns have rifled barrels, but the hard, slightly undersized BBs don't swage or obturate to fit the barrel, so the rifling may not impart a significant spin. These are the type of guns that will benefit most from using precision lead BB shot. The pneumatic BB gun attains much higher velocities than the traditional spring piston types. One interesting use of a pneumatic BB gun is in the calibration of ballistic gelatin, which is done by measuring the penetration of a steel BB at a velocity of about 600 ft/s (180 m/s).

The last common type of power for BB guns is pre-compressed gas, most commonly the 12 gram CO2 powerlet. The powerlet, invented by Crosman, is a disposable bottle containing 12 grams of liquid carbon dioxide, which evaporates to form a gas to propel the BB. These are primarily used in pistol BB guns, and unlike spring-piston or pneumatic types, these are capable of rapid fire. A typical CO2 BB pistol uses a spring-loaded magazine to feed BBs, and a double action trigger mechanism to chamber a BB and cock the hammer. The hammer strikes a valve hooked to the CO2 source, which releases a measured amount of CO2 gas to fire the BB. Velocities of CO2 powered BB pistols are moderate, and drop off as the temperature in the CO2 source drops, due to changes in the vapor pressure. Many CO2 BB guns are patterned after popular firearms, and can be used for training as well as recreation.

Some gas-powered BB guns use a larger source of gas, and provide machine gun-like fire. These types are commonly found at carnivals, and have also been used to train antiaircraft gunners. A popular commercial model was the Larc M-19, which ran off 1 pound (454 g) canisters of Freon-12 refrigerant. These types have very simple operating mechanisms, based on a venturi pump. The gas is released in a constant stream, and this is used to suck the BBs up into the barrel at a very high rate--advertisements for the Larc M-19 claimed a rate of fire of 3000 rounds per minute.